Reading trough forum topics and manuals I have managed to configure Beckhoff EtherCAT EK1100 under the KEB X44.
I have also added EL1809 input and EL2809 output modules. Then I have mapped bus inputs to KRC inputs and KRC outputs to bus outputs.
Those Beckhoff modules were ready installed and wired in the controller.
After deploying and activating project I got errors:
KSS00099 <SYS-X44> Ethercat bus error
KSS13008 Error on reading/writing: SYS-X44
I have made cold start. I have also tried to reset and reconfigure Ethercat drivers but the errors still remains.
Actually there are modules EL9100, EL1809, EL2809, EL3064, EL9100, EL2809 and EL9011 added in EK1100 coupler.
Do I need to add and configure all of them in VW if I would like to test only above mentioned two modules?
I didn't find XML device description files for all and wasn't able to add them to DTM catalog.
What could be wrong and what should I try next?
(KSS 8.3.14 / WV 3.1.7)