Good morning all,
Can anyone tell me how to release the opening of the weld arc in manual mode for level II (editing).
Thank you.
Manual weld in editing level
-
Rafael Schroer -
September 1, 2014 at 1:04 PM -
Thread is marked as Resolved.
-
-
Good Afternoon Rafael,
What is your controller type? - I own several DX100 controllers
"DX100 Operating Welding 155490-1"
manual states
"*Welding can be performed during a test run only when the security mode is the management mode.
*Welding cannot be performed during a test run even while the LED is lit unless the security mode is the management mode. "Yaskawa Support?