Dear friends, good afternoon.
I need to remake KCP2 or X19 cable for KUKA robot.
I have manage to find both connectors ends connector and the cable it self. Also I have test for continuity in all cables to identify its corresponding PIN...All but two of them...PIN A and B.
Any of you have available a cable PINOUT or a cable diagram that could help me solve this issue??
Also...It was impossible to find the cable with the same electrical specs (4 pairs 18 AWG, 4 pairs 22 AWG and 3 pairs 24 AWG), so we decided to make all wires 18 AWG.
Could somebody tell me if this is going to work?? I am worry about cable impedance..
Please advice