Kawasaki JS30 AD EEPROMS needed

    Hi,

    I received JS30 robot with AD-controller today. But unfortunately it seems that someone has replaced motherboard with one from UX series robot so I need EEPROMS from JS30/40 robot or complete 9ZA motherboard from one(it does not have to be working one I just need EEPROLMS). So if anyone can help me out that would be great of course I will pay something for helping me out.

    Tero

    Edited once, last by kwakisaki (January 9, 2016 at 2:45 PM).

    Ok,

    Finally this unit is running again. Real problem was to find correct EEPROMS for 1AE(servo) board. This servo software is unique for robot type(ie. for JS40 it has to be correct for JS40 not JS5 or UX70). We were lucky enough to find a gentleman from Korea who had JS40 with same controller and he was kind enough to read EEPROM's from his unit and send those files to me over email. These EEPROMS are NLA from Kawasaki.

    kawasaki Robotics should be able to burn you the proper EPROMs for your robot and controller. If your board fails it is very unlikely it is the EPROMs and can transfer them to another board if you are careful. You just need to REALLY watch the legs so they don't get bent. It can sometimes be deceiving when you install them.

    I have posted in your other thread too.

    I cannot recall ever loading data into the 1AE, only 1GE.

    The 1AE was always upgraded up erasing the EEPROM and then using a reader/writer to burn the new servo software in.

    So, the only routes I can see are:

    1. Contact Kawasaki and see what their response is.

    2. If someone has the EEPROMS, a read/writer and the original EEPROMS (I'm sure you could still purchase them - but may require some searching).....then they could be replicated as I don't think there is any copy protection on those types of EEPROM used.

Advertising from our partners