KRC2 RDW1

    Hello All;



    Is a possible to operate KRC2 and RDW1 (KRC1) ? Robot is KR 2150/2 and normally running with RDW 2. but when I plug RDW 1 to robot, DSE does not boot up and RDW1 power and communication led not lid.


    Any idea?

    And why do you need to do that ? :smiling_face:


    Original KRC2s were running with RDW1 so it is/was possible but ...
    If I remember correctly software has to be KSS4.x or lower.
    DSE also had to be older model.
    Not sure about series 2000 robots.

Advertising from our partners