help with fanuc S10

    Hi
    I have a fanuc S10. Yesterday, it was operating normally but this morning when I opened upthe resources incidents occurs. SCREEN DISPLAY of Teach pendant does not display and red led in teach pendant is blinking continuously. I want to know my robot is likely to be what?Please help me resolve this problem. Thanks! :help:

    I have tried to make the teach pendant screen displays on the screen and I found out the words "384 r axis excess current in servo". With this error, the robot's what I got? PLEASE HELP ME. thanks

    Edited once, last by GWrobotic (March 28, 2014 at 6:42 AM).

    I can not find that errormessage in my manuals...

    Can you tell us :
    - The controller-type you are using.
    - The software-version.
    - The status of the servo-amplifier(s) (a 1-digit led-number on my robots)
    - The status of the leds on the main cpu-board and the axis control-board.

    Maybe we can tell you more then.

    This afternoon, i had check servo-amplifier. the First, when i turn on power then it normal but when i try move any axis so robot display error "384 r axis excess current in servo". I had seen in servo-amplifier then HCN red led in Servo-amplifier 2 light. . after I have cable insulation r motor shaft servo-amplifier 2 out, I can move the remaining axis. I think servo-amplifier can be hight current??

Advertising from our partners