Dear sir
Today we are facing problem in fanuc robot
Problem : servo45 alarm in Fanuc NOBOT( G2 A2 )
Action : we are check the servo motor cable any damage , checked ok
we check any jig loaded in any other object , no load checked ok
the finally we power recycle done but not ok again one time power recycle done error was clear
then line was running normal.
i need why this problem happen frequently , and what is the root cause of this issue http://www.robot-forum.com/rob…botforum/uglyhammer_2.gif
pl tell me the root cause and why its happen , where i to check
Regards
Senthil.I