i am getting a error on my krc 4 controller that speed of outer fan is too low how to solve this error i have checked the a1-x14 connector on ccu board it is working ok ........ how to get rid off from this error
error outer fan speed too low in krc4........
-
mayank -
August 2, 2013 at 11:05 AM -
Thread is Resolved
-
-
What does $CAB_FANSPEED show?
Sent using Tapatalk 4.
-
Ignore that!
Both my $PC_FANSPEED and $CAB_FANSPEED are at zero, even tough I've no errors...and they are both running.
-
Thanks eusty for replying.......
i tried to run the robot in auto for 1 hour it is facing no error and problem ......i think it was normal status Msg. so until this msg creates no problem i am ok...