June 17, 2019, 05:01:41 AM
Robotforum | Industrial Robots Community

 Help with conveyor tracking on FS100 controller.

normal_post Author Topic:  Help with conveyor tracking on FS100 controller.  (Read 2481 times)

0 Members and 1 Guest are viewing this topic.

September 04, 2013, 06:49:02 PM
Read 2481 times
Offline

SquizzleT


 :help: I am having issues with picking up parts on a constant moving conveyor. I have the robot picking parts up in 2 of the 4 orientations. I programmed the pickup point at X amount of MM down the belt and as long as the part is within 90 degrees of that placement it will pick the part up spot on. If it is completely opposite (180 degrees) of that programmed point it picks the part up 10mm off target only in the -Y direction. All of my tooling is concentric to the T Axis flange also my TCP is set up correctly. All other motions in this program are good except the 180 degree spin on the T Axis. Is there a way to tell the robot to parallel shift +Y if the T Axis is < or > the set point on the vision system tracking job? Been fighting with this for 3 weeks now.   :wallbash:
Curtis T

Today at 05:01:41 AM
Reply #1

Advertisement

Guest


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
IRB 340R conveyor tracking (DSQC 354). Bad accuracy when conveyor acc/dec

Started by MindaugasV85 on ABB Robot Forum

0 Replies
1904 Views
Last post May 21, 2013, 10:39:36 AM
by MindaugasV85
xx
Conveyor Tracking - Place a part on Conveyor

Started by TD_DT on ABB Robot Forum

2 Replies
1476 Views
Last post June 18, 2014, 06:40:41 AM
by TD_DT
xx
Conveyor tracking

Started by Alexandru on Kawasaki Robot Support Forum

1 Replies
2554 Views
Last post July 19, 2015, 06:52:17 PM
by kwakisaki
xx
CONVEYOR TRACKING

Started by paolopi on ABB Robot Forum

4 Replies
915 Views
Last post May 29, 2018, 05:03:14 AM
by TSBV