June 18, 2019, 03:14:10 PM
Robotforum | Industrial Robots Community

 W1170 error code for a panasonic robotic welder

normal_post Author Topic:  W1170 error code for a panasonic robotic welder  (Read 838 times)

0 Members and 1 Guest are viewing this topic.

December 08, 2018, 05:28:42 AM
Read 838 times
Offline

Bradleys71


Robot is stopping without welding, but has attempted to weld and it throws out a w1170 s-side short error. Not sure what this means.

Today at 03:14:10 PM
Reply #1

Advertisement

Guest

December 10, 2018, 02:17:49 PM
Reply #1
Offline

MaLev


Hard to say without more information on the robot, controller and power source.

For Tawers, the operating instructions manual says "Probable cause: Main welding control is not applied in two seconds after detecting the current (probable cause is that the voltage does not rise to the standard voltage.)"

For remedy, it says "Check wire connection on the secondary side of the welding power source if it is short-circuit"

March 31, 2019, 10:58:26 AM
Reply #2
Offline

robotwelder2


If this happens occasionally then this error can be caused by the wire touching the work piece (or being extremely close to the work pice) at arc start.
It can also be caused by too rappid chain welding.
If it happens all the time and you can not weld anymore there is a short between the power source plus-output and ground or your power source is broken.


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
E-7 code on a Panasonic HM 2 500 welder

Started by Kfischer1213 on Panasonic Robots

0 Replies
861 Views
Last post December 04, 2017, 09:04:08 PM
by Kfischer1213
xx
PANASONIC WELDER

Started by Harryusjp on Panasonic Robots

0 Replies
1311 Views
Last post July 30, 2016, 02:44:00 AM
by Harryusjp
xx
panasonic robot welder yd-350hm

Started by werfkast on Panasonic Robots

0 Replies
1894 Views
Last post February 13, 2014, 03:55:36 AM
by werfkast
xx
Interfacing Hi4a controller with Panasonic welder

Started by danielisrael on other Robots

0 Replies
1283 Views
Last post August 18, 2015, 08:32:37 AM
by danielisrael