March 23, 2019, 09:02:37 AM
Robotforum | Industrial Robots Community

 Panasonic TM1800WG3 external axis motor APU01250 parameter settings

Author Topic:  Panasonic TM1800WG3 external axis motor APU01250 parameter settings  (Read 821 times)

0 Members and 1 Guest are viewing this topic.

November 20, 2018, 03:31:06 PM
Read 821 times
Offline

Vaaibhav Goyal


I am using 3.5KW external axis servo motor with Panasonic robot in a Nabtasco make turntable with payload of 3000kg. Gearbox reduction ratio is 1:170. No problem is there while rotating but when the turntable stops, it goes back and forth for few seconds and when servo gets off it stops at its desired position. There is no repeat ability issue but I am not able to stop the vibration at the end. Searched the TP settings for deceleration time settings but could not find it. Tried changing maximum motion speed and all other parameters but no result. I am confused as to what to enter in deceleration ration where in I have been told to enter gearbox reduction ratio. Also I have observed that high speed there is no vibration while stopping but after some cycles Position count over error for external axis is popped. It would be great if you could help.

Today at 09:02:37 AM
Reply #1

Advertisement

Guest

December 12, 2018, 09:27:54 PM
Reply #1
Offline

GMartin


Hi Vaaibhav,

the oscillation could come from backlash in the gearbox if there is to much. In control systems, acceleration is referred to the absolute value, Maximum Acceleration Value field (Motion Parameter>Detail Setting) is where you can change it. After that i would change the loop gain or speed proportion gain.

Hope it Helps.


Just on the side where were you able to get all the parts for the external Axis. We want to add an external axis to our Panasonic welder and I have not heard from Miller in a few weeks.


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
External axis settings

Started by Motouser on Kawasaki Robot Support Forum

10 Replies
983 Views
Last post December 08, 2018, 10:42:43 AM
by Werner Hampel
xx
Add external axis for micro servo motor

Started by Mizio31 on KUKA Robot Forum

10 Replies
2038 Views
Last post September 03, 2017, 12:51:36 AM
by SkyeFire
clip
Mastering homemade external axis with a KR150 KUKA motor

Started by jschmidt on KUKA Robot Forum

8 Replies
1028 Views
Last post June 25, 2018, 10:33:55 PM
by jschmidt
xx
Info on Panasonic Servo Motor

Started by lukebarber on General Discussion of Industrial Robots Only

0 Replies
747 Views
Last post March 22, 2017, 02:54:33 PM
by lukebarber