June 18, 2019, 01:07:32 PM
Robotforum | Industrial Robots Community

 Error panasonic G3-TM1400

normal_post Author Topic:  Error panasonic G3-TM1400  (Read 811 times)

0 Members and 1 Guest are viewing this topic.

October 03, 2018, 05:37:04 AM
Read 811 times
Offline

tv.hinh


Hi everybody,
 I need help error such as picture

Today at 01:07:32 PM
Reply #1

Advertisement

Guest

March 31, 2019, 04:15:54 AM
Reply #1
Offline

biggapple


You may turn off power then open the controller cabinet, then you could see the "release over run switch" on the right side on I/O board. You have to switch it to down then turn on power again.

Next,you have to move all axis to release the current position until the message shown "please turn off and turn on power again" on pendant. Turn off the controller and switch the release over run switch to up position. Then power on again. Hope you can fix the problem.


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
Panasonic G2 Controller Error E4050 I/O Unit Connect Error

Started by jshaffer on Panasonic Robots

0 Replies
912 Views
Last post October 30, 2017, 01:19:48 PM
by jshaffer
question
Panasonic MBDHT2510CA1 driver error codes

Started by Taruuk on Panasonic Robots

0 Replies
3658 Views
Last post March 26, 2014, 01:22:17 PM
by Taruuk
xx
Panasonic VR-OO6L Error E7020 Lock detect TW

Started by swmobrad on Panasonic Robots

1 Replies
2233 Views
Last post July 28, 2014, 02:46:53 AM
by achencan
xx
W1170 error code for a panasonic robotic welder

Started by Bradleys71 on Panasonic Robots

2 Replies
837 Views
Last post March 31, 2019, 10:58:26 AM
by robotwelder2