June 17, 2019, 05:00:42 AM
Robotforum | Industrial Robots Community

 Otc daihen fd11 encoder problem

normal_post Author Topic:  Otc daihen fd11 encoder problem  (Read 234 times)

0 Members and 1 Guest are viewing this topic.

May 08, 2019, 12:53:06 PM
Read 234 times
Offline

Plal1609


hello I have a problem with the robot otc fd11 and so after replacing the battery I get an error message E0052 encoder battery charger low. the robot does not want to move the batteries are new from what I read it is necessary to reset the encoder. here's the question of how to do it. thank you in advance for your help :)

Today at 05:00:42 AM
Reply #1

Advertisement

Guest

May 09, 2019, 04:51:15 PM
Reply #1
Offline

Robotics650


I had a similar problem when i changed batteries in my fd11, i managed to move the robot in joint mode, and redid my TCP, and that fixed my issue.

May 21, 2019, 05:24:16 PM
Reply #2
Offline

FonsCarver


Hi...I am looking at a 2 headstock work cell and notice some have a door or curtain on both sides of the robot between the robot and the headstock and others don’t. Is there a reason for this? Standard possibly? as I want to do what’s right.


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
TCP on a Daihen OTC FD11

Started by Robotics650 on other Robots

1 Replies
1066 Views
Last post May 07, 2018, 05:34:08 PM
by tbex
xx
Daihen OTC FD11

Started by Jrk on other Robots

1 Replies
607 Views
Last post August 01, 2018, 06:28:00 PM
by Pcarbines
xx
Help change wire diameter robot OTC daihen FD11

Started by heri on other Robots

6 Replies
2098 Views
Last post February 16, 2018, 05:26:14 AM
by heri
xx
z series robot with E controller encoder problem

Started by ebb on Kawasaki Robot Support Forum

3 Replies
597 Views
Last post October 24, 2018, 05:46:54 PM
by kwakisaki