June 18, 2019, 03:15:21 PM
Robotforum | Industrial Robots Community

 Virus on an AX controller

normal_post Author Topic:  Virus on an AX controller  (Read 938 times)

0 Members and 1 Guest are viewing this topic.

May 08, 2018, 11:25:04 AM
Read 938 times
Offline

Pep_TK421


Our IT dept. states that we've been hit across the site with the Wanna Cry virus. Two pieces of equipment are our AX20 controllers from 2007. I've tried running the patches and programs IT requested, but I receive no feedback via the teach pendant that anything changed. I'm doing this through Specialist mode, but would developer or integrator mode give me more options? If so, could someone send me the passwords to Pep_TK421@hotmail.com. I've also tried hitting F2 on power up in order to enter setup, but it never goes into setup mode. Thank you for any help!

Today at 03:15:21 PM
Reply #1

Advertisement

Guest

May 09, 2018, 07:31:21 AM
Reply #1
Offline

Roboter


What is the exact alarm or problem you are facing while running the robot ??

May 17, 2018, 06:45:29 AM
Reply #2
Offline

Pep_TK421


No problems whatsoever. IT identified that a couple controllers had the wanna cry virus and we needed to get rid of it. I followed the instructions of running the programs and patches they required. There was no feedback from the teach pendant while I was running the programs, but apparently the scans IT is running on the controllers shows there is no more virus.


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
Virus in the irc5 controller

Started by superboy2000 on ABB Robot Forum

2 Replies
1402 Views
Last post June 02, 2017, 10:23:23 PM
by superboy2000
xx
KRC4 Virus protection

Started by SkyeFire on KUKA Robot Forum

14 Replies
7958 Views
Last post March 03, 2015, 02:42:48 PM
by irobot
xx
Is it recommend that install anti-virus application software on KRC4?

Started by irobot on KUKA Robot Forum

4 Replies
2597 Views
Last post April 02, 2015, 05:50:57 AM
by irobot
xx
UPS failed... Position deviation (motion controller <-> safety controller)

Started by JoanM on KUKA Robot Forum

14 Replies
1396 Views
Last post March 02, 2018, 06:48:28 PM
by JoanM