January 16, 2019, 12:56:19 PM
Robotforum | Industrial Robots Community

 Robot tip warping on OTC NB4L Robot.


Author Topic:  Robot tip warping on OTC NB4L Robot.  (Read 545 times)

0 Members and 1 Guest are viewing this topic.

June 05, 2018, 04:09:06 PM
Read 545 times
Offline

Alroboter


Did anyone else ever have problems with Torch tip constantly being off on OTC Robot?We go to a reference point and bend the tip diffuser back to its original location several times a day,even if we aren't welding very hot.After this the program will be on for a while.Are the diffusers not hard enough? Any advice appreciated.
 ???FD11 model controller, with NB4L Manipulator,through arm 45 degree torch . ???Thanks

Linkback: https://www.robot-forum.com/robotforum/index.php?topic=27080.0

Today at 12:56:19 PM
Reply #1

Advertisement

Guest

June 13, 2018, 01:11:04 PM
Reply #1
Offline

Alroboter


Figured out it was a defective gun.The diffuser did not seat in properly,allowing the threads to bend,which caused the tcp to run off all the time.


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
Benefits of using Small robot on gantry Versus Oversized robot with long reach??

Started by ESIELI on Fanuc Robot Forum

2 Replies
417 Views
Last post July 10, 2018, 09:19:58 AM
by NPG92
thumbup
Dear all pls Answer me for fanuc robot related doubts ,http://www.robot-forum.co

Started by marun_1987 on Fanuc Robot Forum

4 Replies
2594 Views
Last post April 15, 2013, 08:17:39 PM
by worseltes
xx
Create Virtual Robot in Roboguide from image backup of real robot.

Started by jrodriguez on Fanuc Robot Forum

4 Replies
5165 Views
Last post September 24, 2014, 04:06:25 PM
by jrodriguez
xx
Fanuc Robot Axis J4 collision detect alarm and robot droops

Started by dan_robot on Fanuc Robot Forum

2 Replies
3463 Views
Last post June 21, 2013, 11:53:17 AM
by Doctor_C