July 18, 2019, 03:48:28 PM
Robotforum | Industrial Robots Community

 The interface between Beckhoff PLC and Mitsubishi Robot controller

normal_post Author Topic:  The interface between Beckhoff PLC and Mitsubishi Robot controller  (Read 162 times)

0 Members and 1 Guest are viewing this topic.

June 24, 2019, 10:57:15 AM
Read 162 times
Offline

Gregon


Hello all,
I am a beginner in PLC programming. I am working with Beckhoff PLC and now trying to integrate Mitsubishi robot to the PLC. Mitsubishi robot controller (CR2D 700) supports Ethernet TCP/IP, RS 232, CC link port.
Since I am new to this robotics I am stuck on how to integrate and communicate Beckhoff PLC and robot controller. I have gone through robot controller manuals and it's programmed using Melfa basic and there is the syntax to open an ethernet port and receive and send data. With Mitsubishi PLC integration it is a very simple because of Mitsubishi IQ platform.
But I am little stuck with how to communicate Beckhoff plc with the robot controller. So please share your ideas and help me with this.
Thanks in advance.

Today at 03:48:28 PM
Reply #1

Advertisement

Guest


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

question
mitsubishi rv 1a robot and MELFA CR1-571 Controller problem

Started by jone.smith on Mitsubishi Robot Forum

3 Replies
2611 Views
Last post December 10, 2016, 01:46:23 PM
by MeanMit
xx
DeviceNET interface Yaskawa DN4-PCU1 x Fronius TPS CMT Beckhoff BK5250

Started by vat on Yaskawa Motoman Robot Forum

10 Replies
4506 Views
Last post October 16, 2016, 10:50:24 AM
by marnsh
clip
Mitsubishi Robot RV-2AJ

Started by srmrobotics on Used Robots and parts

0 Replies
1417 Views
Last post February 13, 2014, 11:24:12 AM
by srmrobotics
question
Mitsubishi Arm Robot communication with PC

Started by Body on Mitsubishi Robot Forum

4 Replies
2899 Views
Last post September 24, 2018, 03:47:58 AM
by NHaman