January 17, 2019, 07:31:00 PM
Robotforum | Industrial Robots Community

 MXT XYZ position and Joint angle control


Author Topic:  MXT XYZ position and Joint angle control  (Read 1088 times)

0 Members and 1 Guest are viewing this topic.

February 02, 2017, 05:45:09 AM
Read 1088 times
Offline

Body


Hello people,

I am trying to control the joints and the XYZ position of my robot simultaneously using MXT with external PC, however, MXT receives only one type of command at a time or it will send an illegal MXT error, so I need to switch between MXT 1,0 to MXT 1,1

Is there any variable that changes when MXT receives the command packet? or is there any way to access the received  packet from robot side ?

I am using CIROS programmer by the way.

thanks in advance

Linkback: https://www.robot-forum.com/robotforum/index.php?topic=22251.0
  • Like    Thanks

Today at 07:31:00 PM
Reply #1

Advertisement

Guest


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
Joint Angle

Started by gdemark on Fanuc Robot Forum

4 Replies
2876 Views
Last post April 17, 2014, 08:16:50 PM
by flatcurve
clip
How to Input Joint angle variation profile in KUKA (either in KRC2 or iiwa)?

Started by MECHI on KUKA Robot Forum

5 Replies
2640 Views
Last post May 14, 2015, 05:26:09 PM
by MECHI
xx
Moving the tool to a calculated position on an angle

Started by Henry Dam on Kawasaki Robots

7 Replies
3023 Views
Last post January 14, 2016, 07:35:21 PM
by kwakisaki
xx
iiwa 14 FRI Joint specific torque control

Started by ahnjmo1993 on KUKA LBR IIWA

2 Replies
734 Views
Last post October 18, 2018, 07:48:22 AM
by DrG