June 19, 2019, 03:05:08 AM
Robotforum | Industrial Robots Community

 KPS600 Lights

normal_post Author Topic:  KPS600 Lights  (Read 188 times)

0 Members and 1 Guest are viewing this topic.

June 12, 2019, 06:40:10 PM
Read 188 times
Offline

Pyrojaymez


Hello fellows,

We recently had the cabinet(KRC2 ed05) moved, We had to disconnect the main power to get it where we wanted. I powered it back up an now I can not move the robot. I get the message: 1376 Active Commands Inhibited. I looked at the drives and they are all blinking green slowly. Looking in my little hand book, That means "Uic < Ulim"
I don't really know what that means.
I also see the KPS has led 2 flashing. little book says "Intermediate circuit < 60v"

To me, this sounds like its not getting power correctly. I checked fuses, they all seem good. I've been reading a bunch of other posts on here and one said to try starting it up with the X11 jumper which implies a safety circuit fail.

My questions are: Does this sound like a safety circuit problem? What can I do do get more info?

I have a hard time believing that moving it 10 feet cause the safety this much trouble.

Today at 03:05:08 AM
Reply #1

Advertisement

Guest

June 13, 2019, 12:21:05 AM
Reply #1
Offline

panic mode

Global Moderator
enable drives. in T1 that means holding enabling switch (assuming all the safety is wired correctly and $MOVE_ENABLE is true)
1) http://www.robot-forum.com/robotforum/kuka-robot-forum/read-first/
2) if you want reply about robot, post it in forum
3) read 1 and 2

June 13, 2019, 10:52:30 AM
Reply #2
Offline

Pyrojaymez


When I do that I get the message " active commands inhibited".

June 13, 2019, 01:23:03 PM
Reply #3
Offline

SkyeFire

Global Moderator
What other messages are being displayed?  "Active Commands Inhibited" is not a message that occurs alone -- it's always a secondary effect of some other error message.


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
regarding kps600 and ESC board

Started by kishan on KUKA Robot Forum

7 Replies
651 Views
Last post October 17, 2018, 08:42:56 PM
by panic mode
xx
KPS600 Repair?

Started by RobotsRock on KUKA Robot Forum

1 Replies
1739 Views
Last post August 01, 2014, 11:32:17 AM
by repairsolutionuk
xx
Need to change KPS600/20 (V)KRC2 ed05

Started by ar.klimov on KUKA Robot Forum

0 Replies
429 Views
Last post April 16, 2018, 03:52:30 PM
by ar.klimov
clip
ALL Pendant lights are ON

Started by amarkangda on Yaskawa Motoman Robot Forum

3 Replies
1140 Views
Last post March 18, 2017, 04:23:16 PM
by asgary64