March 21, 2019, 12:02:15 AM
Robotforum | Industrial Robots Community

 z series robot with E controller encoder problem

Author Topic:  z series robot with E controller encoder problem  (Read 497 times)

0 Members and 1 Guest are viewing this topic.

October 23, 2018, 06:20:45 PM
Read 497 times
Offline

ebb


Hello Dears

we have two z series robots.
one of them fall in a problem.
the problem was :
(E1034) Encoder initialize error Jt 1)
I found that encoder or motor drive have problem.

I toke out encoder from the correct robot (that robot was OK)
and put it in damaged robot.
Now, i dont have E1034 Error but now i have
(E1123) speed error j1

I toke encoder out  again and put it in OK (correct) robot,
Unfortunatly i have E1123 in correct robot,too 

what i have to do?

note: i did not change motor with encoder
i only changed encoder.

Today at 12:02:15 AM
Reply #1

Advertisement

Guest

October 23, 2018, 09:29:19 PM
Reply #1
Offline

kwakisaki

Global Moderator
Encoder initialize error usually always failure of encoder, so your diagnosis appears correct, however it is never advisable to exchange working encoder from other robot for testing as accidental damage can occur.
- I suspect possible internal cable connection or damage to encoder during re-attachment.
- Check and confirm connections and also central retaining washer and bolt are secure, if ok, then I suspect encoder is now faulty.

October 24, 2018, 09:21:01 AM
Reply #2
Offline

ebb


Thanks for your kindly attention
It was for central retaining washer.

October 24, 2018, 05:46:54 PM
Reply #3
Offline

kwakisaki

Global Moderator


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter