June 17, 2019, 05:17:09 AM
Robotforum | Industrial Robots Community

 D controller boot problem !!

normal_post Author Topic:  D controller boot problem !!  (Read 164 times)

0 Members and 1 Guest are viewing this topic.

April 13, 2019, 01:11:18 PM
Read 164 times
Offline

HenryBraxton


Hi All,

 I have a problem with D controller boot up (with FS 06N arm). The pendandt stopped at the kawasaki logo. There is no error message, but the 1KA board battery was dead. I attached photos.

Any help would be appreciated.

 Thank you.

Today at 05:17:09 AM
Reply #1

Advertisement

Guest

April 13, 2019, 02:27:49 PM
Reply #1
Offline

kwakisaki

Global Moderator
Welcome to the forum.......... :beerchug:

1. Replace the battery.
2. Reboot and see if ok............if not then, turn Controller off and then:
3. Set dipswitch 1 and 8 ON on 1KA board.
4. Reboot Controller and go through 999 initialisation.
5. Reload recent file save.
6. Turn off Controller and set dipswitch 1 ON (Turn 8 Off) and reboot.
7. Ignore errors, goto AUX 0803 (Clear Check Sum Error) and enable clear check sum.
8. Reset all errors.
9. If no error exists, should be ok, if error exists post back.

If it still hangs on the logo screen and you cannot do above, it is possible that:
- AS and SV Firmware is required to be loaded (These versions are contained in the header of a file save).
- There is a problem on the 1KA or 1KB Board.

Let us know if it works, if not then please provide:
- File save.

I will try and obtain applicable firmware files and procedures to re-load.
« Last Edit: April 13, 2019, 02:54:31 PM by kwakisaki »


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

clip
D controller boot problem

Started by tlorincz72 on Kawasaki Robot Support Forum

2 Replies
827 Views
Last post March 14, 2018, 01:02:24 PM
by tlorincz72
xx
Boot type to cold boot by default and FTCtrl/hibernate problem.

Started by vrahikka on KUKA Robot Forum

2 Replies
3015 Views
Last post June 11, 2013, 05:15:46 PM
by vrahikka
xx
S4C+ boot problem

Started by jore on ABB Robot Forum

6 Replies
3933 Views
Last post September 29, 2015, 05:13:24 PM
by Iowan
xx
Boot problem S4C IRB 1400

Started by Christ on ABB Robot Forum

2 Replies
1353 Views
Last post September 09, 2017, 04:17:55 AM
by Skooter