March 25, 2019, 02:35:32 PM
Robotforum | Industrial Robots Community

 RS232 Communication configuration

Author Topic:  RS232 Communication configuration  (Read 143 times)

0 Members and 1 Guest are viewing this topic.

March 12, 2019, 06:42:30 PM
Read 143 times
Offline

malain


Hi,

I try to configure the rs-232 port on my controller (LR mate 200iC, V7.40).  If i use the TP menu (Menu/Setup/PortInit) I only can change Baudrate, Parity, StopBit.   But I also need to change to 7 or 8 bits data communication, Xon/Xoff.

So by using Karel, I can use the command SET_PORT_ATR and GET_PORT_ATR to get access to all these config, but I don't work.
The following line :
stat=SET_PORT_ATR(PORT_2,ATR_DBITS,DBITS_8)
return 17036 in the Stat variable

The following line :
stat = GET_PORT_ATR(PORT_2,ATR_DBITS,atr_value)
return 17036 in the Stat variable

So, how must I use these command???
AND
Where can I found the signification of the Status 17036???

Thanks


Today at 02:35:32 PM
Reply #1

Advertisement

Guest

March 15, 2019, 03:18:39 PM
Reply #1
Offline

malain


the 17036 code seem to be for ROUT-036 : Illegal PORT....     but why!?!?! 

If anyone have some kind of clue?


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
SA3 communication with PC RS232

Started by carter15 on ABB Robot Forum

0 Replies
131 Views
Last post January 22, 2019, 09:32:49 PM
by carter15
xx
Fanuc RJ3iB RS232 Communication

Started by BLedbetter on Fanuc Robot Forum

3 Replies
1900 Views
Last post February 02, 2019, 04:30:11 PM
by kotam
xx
How to DX100 RS232 communication settings ?

Started by Cho. Sung Ryong on Yaskawa Motoman Robot Forum

5 Replies
3871 Views
Last post September 19, 2014, 09:14:41 PM
by Ardbeg
xx
Melfa rv-2aj PC control using rs232 communication

Started by bogdan.sarealba on Mitsubishi Robot Forum

7 Replies
8117 Views
Last post July 03, 2016, 11:05:17 PM
by kensh