Robotforum | Industrial Robots Community

Industrial Robot Support and Discussion Center => Fanuc Robot Forum => Topic started by: lucasking on February 08, 2019, 03:19:21 AM

Title: Kemppi Arc + FANUC
Post by: lucasking on February 08, 2019, 03:19:21 AM

Good night people.
I have a FANUC robot with a Kemppi soldering machine with the K60 controller. What happens is when I change my welding settings in the schedules, the wire does not accept the values. The values ​​are only accepted if inserted directly in the welding machine. Other values ​​such as voltage and feedrate also do not respond.
Title: Re: Kemppi Arc + FANUC
Post by: dha on February 11, 2019, 04:48:53 PM
Do you have digital or analog communication?

Look for digital signal Online or Kemppi Online. If you want to send welding parameters from robot to power source this signal must be ON.

If it's OFF, KempArc weld with parameters set in selected Channel.