Robotforum | Industrial Robots Community

Industrial Robot Support and Discussion Center => Fanuc Robot Forum => Topic started by: lavaman on May 12, 2018, 03:36:16 PM

Title: How To Remove TP Files Effectively from virtual teach pendent in roboguide
Post by: lavaman on May 12, 2018, 03:36:16 PM
There are hundreds of TP Programs in the virtual robot controller which may result in computer running slowly。

I want to remove this TP Programs one by one while there are so many TP Files that become a headache。

Is there a way to remove hundreds of TP Programs effectively?


many thanks.

(http://)
Title: Re: How To Remove TP Files Effectively from virtual teach pendent in roboguide
Post by: lavaman on May 20, 2018, 11:58:54 PM
Init Start on the vitral robots will remove these unusefull files  :cheer:
Title: Re: How To Remove TP Files Effectively from virtual teach pendent in roboguide
Post by: Nation on May 21, 2018, 01:32:42 PM
That will remove all files, and IO configs, and everything else.

My method would be to connect to the virtual robot via ftp and remove the files that way. Another way would be to use a .cm file, described in the sticky.