March 21, 2019, 12:13:45 AM
Robotforum | Industrial Robots Community

 FTP Error 550

Author Topic:  FTP Error 550  (Read 551 times)

0 Members and 1 Guest are viewing this topic.

July 13, 2018, 09:35:01 PM
Read 551 times


Hello again everybody,
Just an hour ago I was able to use ftp to transfer files/programs to my Fanuc LR Mate 200iD/7L (controller: R-30iB Mate Plus), however, now whenever I try to push a .ls file down I get error 550, which is supposed to mean I do not have permissions to write to the directory I am connected to but I did not do anything different than I did earlier today... anyone have any ideas what might have changed? Alternativly, how can I give myself full RW access to the MD directory?
« Last Edit: July 13, 2018, 09:42:05 PM by just_learning_KRL »

Today at 12:13:45 AM
Reply #1



July 13, 2018, 09:38:25 PM
Reply #1


This is the output I get from the command line:
Code: [Select]
ftp> put
200 PORT command successful.
150 ASCII data connection.
550 Error occurred during load
ftp: 1019 bytes sent in 0.17Seconds 5.86Kbytes/sec.

July 13, 2018, 10:04:15 PM
Reply #2


There was a syntax error in my file, I had set X to 0 mm, all I did was change it to 0.00 mm and it transfered fine. I guess the precision matters...

Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter