March 22, 2019, 02:41:24 PM
Robotforum | Industrial Robots Community

 FANUC SERVO PARAMETER

Author Topic:  FANUC SERVO PARAMETER  (Read 751 times)

0 Members and 1 Guest are viewing this topic.

October 18, 2018, 12:17:25 PM
Read 751 times
Offline

AUTOMANITION


Someone knows how we can see the servos parameters ?

Today at 02:41:24 PM
Reply #1

Advertisement

Guest

October 19, 2018, 11:38:11 AM
Reply #1
Offline

byrol


Are these the values ​​you're looking for?

October 19, 2018, 01:18:47 PM
Reply #2
Offline

AUTOMANITION


yes, can we change them ?
I mean, can we see and adjust load parameters ?
How I can see and adjust those parameters ??

thank you !

October 19, 2018, 08:03:32 PM
Reply #3
Offline

byrol


I never changed these parameters. As far as I know, this process is not a recommended setting. It can lead to irreversible failure and can lead to many mechanical problems. For some parameter changes, "Cold Start" is sufficient. For some parameters, you may need to do "init start". You need to do very good research on the changes you want to make.

October 22, 2018, 01:08:57 PM
Reply #4
Offline

AUTOMANITION


Ok thank you.
My concern about that is that I need to change my PAYLOAD or increase the torque limit for 1 joint...
Do you know how I can do this ?

October 22, 2018, 04:08:27 PM
Reply #5
Offline

pdl


MENU > SYSTEM > MOTION

This is where the payload schedules can be viewed and modified.

SETUP > COLLISION GUARD will allow you to change the values for the torque limits.

October 22, 2018, 07:32:58 PM
Reply #6
Offline

Racermike123


Menu>0>4
Press the arrow key next to F5 and select disturb, you can manually change the torque settings for each axis. It changes back when you cycle power

Today at 02:41:24 PM
Reply #7

Advertisement

Guest

October 23, 2018, 12:48:33 PM
Reply #7
Offline

AUTOMANITION


I don't see DISTURB...

October 23, 2018, 04:06:04 PM
Reply #8
Offline

Racermike123


Did you press the arrow key next to F5?
If you did it will look like this


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
servo speed parameter

Started by rupy on Fanuc Robot Forum

7 Replies
4428 Views
Last post September 24, 2015, 08:10:28 PM
by cph5140
xx
KR6 axis 2 synchronization error and incorrect servo parameter error

Started by DanT123 on KUKA Robot Forum

2 Replies
1521 Views
Last post May 02, 2016, 07:36:15 PM
by DanT123
xx
fanuc error servo 105 and servo 264

Started by dario fanc on Fanuc Robot Forum

3 Replies
2454 Views
Last post March 15, 2016, 09:26:40 PM
by dario fanc
xx
FANUC ROBOT BRAKE RELEASE PARAMETER

Started by inferno on Fanuc Robot Forum

0 Replies
2552 Views
Last post August 09, 2014, 05:59:36 PM
by inferno