July 18, 2019, 04:09:48 PM
Robotforum | Industrial Robots Community

 DCS not active on R30iB

normal_post Author Topic:  DCS not active on R30iB  (Read 1925 times)

0 Members and 1 Guest are viewing this topic.

February 05, 2016, 09:57:17 PM
Read 1925 times
Offline

vrbasgrad


My DCS was set up and active but I had to do minor change on some zones and now DCS output from robot that acknowledge DCS active is off. All my zones are safe and there is not error on the pendant, I also applied new changes and it seems ok but somehow I lost DCS active output from the robot. Any idea I would appreciate.
Thx

Today at 04:09:48 PM
Reply #1

Advertisement

Guest

March 07, 2016, 04:13:08 PM
Reply #1
Offline

millerm213049


Are you referring to getting an output to the PLC? When you set up your DCS a safety signature is produced. That signal is usually implemented into the PLC as part of the safety circuit. If you make even minor changes to the DCS parameters the the signature will change and effect what output the PLC is seeing if they do not change the signature on there end.

March 07, 2016, 04:19:33 PM
Reply #2
Online

Nation

Global Moderator
On some systems you have to announce that the new settings are good for the PLC to accept them. This is done under "Signature number" and then you hit F5 once in there for the announcement.
Check out the position converter I wrote here!


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

clip
Archive not active

Started by Tabanov on KUKA Robot Forum

12 Replies
5990 Views
Last post October 08, 2014, 06:43:02 PM
by Tabanov
xx
Active motion stopped

Started by Plc_User on Fanuc Robot Forum

1 Replies
912 Views
Last post January 20, 2017, 01:29:36 PM
by skalactik
xx
Changing active equipment

Started by dha on Fanuc Robot Forum

0 Replies
1027 Views
Last post September 21, 2016, 06:33:13 AM
by dha
xx
contactor active error!

Started by OverThere on ABB Robot Forum

3 Replies
4245 Views
Last post June 26, 2014, 07:43:20 AM
by OverThere