Author Topic: FTP Error 550  (Read 93 times)

0 Members and 1 Guest are viewing this topic.

Offline just_learning_KRL

  • Newbie
  • *
  • Thank You
  • -Given: 3
  • -Receive: 1
  • Posts: 48
FTP Error 550
« on: July 13, 2018, 09:35:01 PM »
Hello again everybody,
Just an hour ago I was able to use ftp to transfer files/programs to my Fanuc LR Mate 200iD/7L (controller: R-30iB Mate Plus), however, now whenever I try to push a .ls file down I get error 550, which is supposed to mean I do not have permissions to write to the directory I am connected to but I did not do anything different than I did earlier today... anyone have any ideas what might have changed? Alternativly, how can I give myself full RW access to the MD directory?
Thanks!
« Last Edit: July 13, 2018, 09:42:05 PM by just_learning_KRL »

Offline just_learning_KRL

  • Newbie
  • *
  • Thank You
  • -Given: 3
  • -Receive: 1
  • Posts: 48
Re: FTP Error 550
« Reply #1 on: July 13, 2018, 09:38:25 PM »
This is the output I get from the command line:
Code: [Select]
ftp> put prog.ls
200 PORT command successful.
150 ASCII data connection.
550 Error occurred during load
ftp: 1019 bytes sent in 0.17Seconds 5.86Kbytes/sec.

Offline just_learning_KRL

  • Newbie
  • *
  • Thank You
  • -Given: 3
  • -Receive: 1
  • Posts: 48
Re: FTP Error 550
« Reply #2 on: July 13, 2018, 10:04:15 PM »
Solved!
There was a syntax error in my file, I had set X to 0 mm, all I did was change it to 0.00 mm and it transfered fine. I guess the precision matters...