December 14, 2018, 03:49:26 AM
Robotforum | Support for Robotprogrammer and Users


Author Topic:  Fanuc F-Number  (Read 209 times)

0 Members and 1 Guest are viewing this topic.

December 08, 2018, 10:07:03 PM
Read 209 times
Offline

lepm4


I have a question about F-number. It is possible to change the F-number in a  r30ib plus  through the systeme variable?

Long story short,
we have 2 identical robots.
I transfer a bunch of file from a All Of The Above back-up from robot 1 to robot 2 to save time on the start up.
The problem is that now, both robot has the same F-number.
I transfer a file that I shouldn't but I don't know which one.
Is there a way to put back the right F-number in robot 2 without doing a factory reset and losing everything?
  :merci:



« Last Edit: December 09, 2018, 02:34:49 PM by lepm4 »

December 09, 2018, 06:28:18 PM
Reply #1
Online

HawkME


Boot the robot in a controlled start and you will see the F number that you can change.

Hopefully you didn't overwrite the mastering file? If so you should be able to re-enter the master counts from the data sheet.

Sent from my SM-G930V using Tapatalk


December 09, 2018, 07:05:53 PM
Reply #2
Offline

lepm4


Thank you, I will try that.
No mastering count are good. Everything else is working fine except the F-Number not matching.

December 10, 2018, 01:11:22 PM
Reply #3
Offline

Sergei Troizky


Are you sure the controller ID F-numbers were different from the beginning?
Identical robots from the same order may have matching controller ID, while nameplated with different F numbers.

December 10, 2018, 01:52:44 PM
Reply #4
Online

HawkME


Even so, I still go in and enter the correct F number so it matches the nameplate. Controller ID and F number are two different numbers on the controlled start menu.

December 11, 2018, 01:06:34 PM
Reply #5
Offline

rob76


Variable for F number is : $FNO
No need for CTRL Start to change this.

Looks like you loaded the sysvars.sv file from the other robot. ($FNO Variable should be in there).