March 21, 2019, 12:08:06 AM
Robotforum | Industrial Robots Community

 Issue with auto-teach in Robcad

Author Topic:  Issue with auto-teach in Robcad  (Read 1497 times)

0 Members and 1 Guest are viewing this topic.

August 11, 2016, 07:21:14 AM
Read 1497 times
Offline

Adi


Dear All,

     I am Adi from Bengaluru, India. I am facing an issue with auto teach in Robcad 9.0 for Kuka controller krc1_spot. The issue is that auto teach locations(local locations) are being created but the config of the robot is not being updated in teach pendant. Also i tried to download the program after auto teach but the error says that the locations are not teached.

Please find an attached image which describes my issue clearly & help me solve this issue. :help:

Regards,
Adithya

Today at 12:08:06 AM
Reply #1

Advertisement

Guest


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

question
Issue with auto-teach in Robcad

Started by Adi on KUKA Robot Forum

0 Replies
780 Views
Last post August 11, 2016, 04:47:08 AM
by Adi
clip
Auto-teach issue in Robcad

Started by Adi on KUKA Robot Forum

0 Replies
894 Views
Last post August 08, 2016, 11:25:18 AM
by Adi
xx
Teach Pendant issue

Started by tmfending on ABB Robot Forum

1 Replies
253 Views
Last post October 30, 2018, 02:17:04 PM
by Iowan
xx
How to configure teach pendant to run in auto?

Started by Capin on ABB Robot Forum

1 Replies
1685 Views
Last post May 20, 2015, 10:49:49 PM
by bob865