January 16, 2019, 12:22:51 PM
Robotforum | Industrial Robots Community

 RC5 gives 73ff error Can't start during program stop


Author Topic:  RC5 gives 73ff error Can't start during program stop  (Read 1173 times)

0 Members and 1 Guest are viewing this topic.

February 07, 2018, 11:25:28 AM
Read 1173 times
Offline

niko


The title pretty much says it all .
TSR program runs but when it runs a subprogram (for homing movement) 73ff comes up . Not much in the manual about it and this is the second time I got this error, and it is persistent . Powering of does not help .
Re-uploading and  restarting the project did the trick last time but I'd like to know how to avoid this issue in the future .

Any help is welcome .

Regards
Nikolai


Linkback: https://www.robot-forum.com/robotforum/index.php?topic=25777.0

Today at 12:22:51 PM
Reply #1

Advertisement

Guest

March 20, 2018, 12:49:31 PM
Reply #1
Offline

esp400


Nikolai,

Was the program stopping when the robot was trying to home?  If so, how is the robot stopped( e.g. externally through PLC hard signal like step stop OR programming?).   From what I can gather online, it looks as if the robot is HALT-ing when you are trying to home it.

April 02, 2018, 12:48:48 PM
Reply #2
Offline

niko


Hello and thank you for your reply !
It seems one axes was close to it's end of travel, and that's what caused it .
Now I have issues with maneuvering in tight spaces .
Any tips with that ?

April 12, 2018, 04:20:41 PM
Reply #3
Offline

esp400


Assuming your moves are linear already?


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

question
Program start and stop button frozen

Started by piyushjadhav on KUKA Robot Forum

1 Replies
726 Views
Last post March 11, 2017, 10:56:33 AM
by Fubini
xx
Auto mode start/stop program

Started by Robotony on KUKA Robot Forum

25 Replies
9525 Views
Last post October 26, 2016, 07:48:19 PM
by Robotony
xx
Stop Spindle at Robot Stop for program error

Started by Marco on KUKA Robot Forum

11 Replies
2894 Views
Last post June 14, 2018, 09:41:29 AM
by Marco
clip
KRC2 Cross3 start up program unable to start

Started by jschmidt on KUKA Robot Forum

1 Replies
549 Views
Last post January 23, 2018, 03:22:45 AM
by Ceta11