June 19, 2019, 03:06:07 AM
Robotforum | Industrial Robots Community

 Cobotta Calset Concern

normal_post Author Topic:  Cobotta Calset Concern  (Read 119 times)

0 Members and 1 Guest are viewing this topic.

May 28, 2019, 04:36:41 PM
Read 119 times
Offline

randz113


Hi,

Good Day!

Right now, we are setting up the Cobotta Robot.
Can I ask if there are solutions to retain the Calset Data that was used before teaching the robot?
Thus, I will not always make Calset Operation every start up/power on of Cobotta.

Everytime I shutdown and Power ON the Robot, there's a pop-up that I need to make Calset.
After the Calset, when I checked the saved programs, the positions were all offset.

Thank you in advance for helping me.

Best regards,

randz113

Today at 03:06:07 AM
Reply #1

Advertisement

Guest


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
Cobotta version

Started by Nzhuhu on Denso Robot Forum

2 Replies
711 Views
Last post February 20, 2019, 06:24:51 PM
by Nzhuhu