March 23, 2019, 09:02:58 AM
Robotforum | Industrial Robots Community

 TCP information

Author Topic:  TCP information  (Read 281 times)

0 Members and 1 Guest are viewing this topic.

January 08, 2019, 02:11:14 PM
Read 281 times
Offline

David.mms


I am trying to set up a robot in an offline programming software and need information on the current TCP, coordinate systems, reference system for our ABB IRB 2400L. Would I be able to get this information from a backup of the controller?

Today at 09:02:58 AM
Reply #1

Advertisement

Guest

January 08, 2019, 03:32:54 PM
Reply #1
Offline

Lemster68


Yes, you will need to find the module in which the Tooldata and Workobject data are declared.

January 09, 2019, 12:24:29 PM
Reply #2
Offline

David.mms


Thanks I was able to find it. There are values for trans, rot, cog and aom. Would I need all of these values or would it only be xyz in trans and the q1-q4 in rot. I can attach an image if necessary

January 09, 2019, 12:35:16 PM
Reply #3
Offline

LEC2016


You will need all the values..


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

question
Need Information

Started by sandeep.lerio on ABB Robot Forum

0 Replies
960 Views
Last post June 16, 2016, 04:36:23 AM
by sandeep.lerio
xx
X27 information

Started by scotty on KUKA Robot Forum

1 Replies
957 Views
Last post August 11, 2016, 09:51:31 PM
by scotty
sad
gripper information

Started by bigboss on KUKA Robot Forum

5 Replies
3491 Views
Last post January 26, 2015, 07:41:53 AM
by bigboss
clip
Information about memory

Started by toso on Fanuc Robot Forum

4 Replies
2161 Views
Last post February 21, 2017, 12:05:26 PM
by toso