February 22, 2019, 04:20:44 AM
Robotforum | Industrial Robots Community

 Robot 6400R digital to analogue output module

Author Topic:  Robot 6400R digital to analogue output module  (Read 135 times)

0 Members and 1 Guest are viewing this topic.

February 12, 2019, 03:08:39 PM
Read 135 times
Offline

David.mms


I am trying to use an ABB 6400R robot with a spindle tool. I would like to be able to send an analogue signal from the robot to the spindle to allow different speeds to be set for the spindle. Would anyone know the best way to do this?

Today at 04:20:44 AM
Reply #1

Advertisement

Guest

February 12, 2019, 09:22:17 PM
Reply #1
Offline

Lemster68


The important thing we need to know is what is controlling your spindle?  I suppose it is capable of receiving an analog input?  It is also possible to configure a group of digital signals to be sent and read like analog.  What interface does the spindle controller have?  What are your communication buses/protocols?

February 13, 2019, 03:45:27 AM
Reply #2
Offline

SAABoholic


The best way to send an analog signal would be to install an analog (or combi) I/O board  :zwink:



Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
Fanuc M-16iB, continuously monitor analogue input, and drive an digital output

Started by Duffer on Fanuc Robot Forum

3 Replies
375 Views
Last post October 30, 2018, 10:24:54 AM
by Racermike123
xx
switching on and off digital output depending on logic of 2 digital inputs

Started by Kroket on ABB Robot Forum

5 Replies
2047 Views
Last post August 29, 2013, 06:39:59 PM
by JoanM
xx
Firing a Digital output when robot is in alarm

Started by Liburdi on Fanuc Robot Forum

3 Replies
1894 Views
Last post June 04, 2014, 12:14:11 PM
by towerguil
xx
Digital output high only when robot is busy

Started by vipinpunneri on Fanuc Robot Forum

3 Replies
2001 Views
Last post February 02, 2016, 02:26:27 PM
by HawkME