June 17, 2019, 04:56:52 AM
Robotforum | Industrial Robots Community

 DNet 709-1

normal_post Author Topic:  DNet 709-1  (Read 456 times)

0 Members and 1 Guest are viewing this topic.

June 13, 2018, 06:17:47 PM
Read 456 times
Offline

aftab_khan


hello to all...
in IRC5 for communication there is only DeviceNet 709-1 Master/Slave card. I want to control IRC5 as slave to PLC S7-1200. For prfinet to Devicenet i use anybus gateway.
when i configure gateway with Gateway as a Slave to IRC5 (byte size 20) it starts communication with Gateway but when i want to take IRC5 as a Slave and configure it as slave with polled connection and RX/TX size 20 bytes, it gives an error,
(Device failed to Initialize, timeout ).
is there some issue with 709-1 Card , it can only behave as a master or can be configured as slave.
any help plzzzz i have tried soo many times using DN-Slave also (just change vendor id and code in DN-Slave ) also add a new unit type HMS-Gateway and link it to new unit but nothing works for me...
any help from ABB plz. i don't know why the bit in plc not communicating to IRC5... :wallbash:

Today at 04:56:52 AM
Reply #1

Advertisement

Guest


Share via facebook Share via linkedin Share via pinterest Share via reddit Share via twitter

xx
New Fanuc devicenet configuration problem Dnet-060 and dnet-104

Started by Kask on Fanuc Robot Forum

1 Replies
1086 Views
Last post May 21, 2018, 12:04:58 AM
by Kask
xx
RJ-3 Dnet-084 error

Started by Chev454ss on Fanuc Robot Forum

2 Replies
2645 Views
Last post December 07, 2018, 06:50:13 PM
by mortoch
xx
DNET Error help needed

Started by gauravu on Fanuc Robot Forum

2 Replies
2151 Views
Last post February 06, 2017, 07:36:45 PM
by mortoch
xx
DNET MINIWIDE ISSUES

Started by Tlalóc on Fanuc Robot Forum

0 Replies
285 Views
Last post June 12, 2018, 08:38:17 PM
by Tlalóc