File Size or point limitation with NX100

[RoboCAM]

Hi all,

I know there is a point limitation on the NX100 of about 60,000 points. What I'm not sure about is; can that number of points be in one (1) .jbi file or is there a single file size limit as well?

Thanks,

Adrian Potter
www.robocam.com.au

[motomaniaco]

RoboCam,

The size limit for NX100 is 9999 lines on a job, it includes steps and instructions. I checked it on an early software version, I don´t know if there is a change on the newest versions.

[95devils]

The maximum number of lines a job can have is 10,000.  The line numbering goes from 0000 NOP up to 9999.  The maximum number of steps would be 999.  The step numbering starts with step 1 and goes to 999.  If you display step number by touching in the MENU Area on Display then from the drop down ENABLE STEP NUMBER it will show that the step number is a three digit number.