XRC Externally start and hold

[wavemill]

Dear,

For the moment we use the start and hold directly on the cabinet.
Is it possible to externalize it ,i would like to put it near my welding table?
Thank you for your advice and help!

Wavemill

[Pcarbines]

Yes,  they are designed to have Remote Start , stop & servo on functions Etc. . Please look in "Instructions" manual. Specific Input Circuit Board wiring draw.& General i/o assignment CN12 connector terminals B1 , B3 (remote) ,A3 (Play) and B4 (Teach) > to >  A7 or B7.
 This might be more than you need ,but it's relatively easy to setup.
It's designed for layouts that could have the Controller in a Hard place for every day access, up in roof space is one I can think of.
If you simply want a remote start/stop station then you can wire inputs and designate the numbers used and wire in the series hold circuit   and then "enable" the internal "Station software" .
If you haven't manual, please advise by email.
How many welding stations are you wanting??

[Robodoc]

You can buy a remote operator station from Motoman that comes with all the options you need and a diagram on how to connect it.