Welcome, Guest. Please login or register.
Did you miss your activation email?
May 24, 2012, 01:20:58 PM
Home Help Login Register
News: Any Problems or Experience with Industrial Robots ?
Register and place your Question / Answer to worldwide Robotexperts right here !

+  Robotforum | Support for Robotprogrammer and Users
|-+  Industrial Robot Help and Discussion Center
| |-+  Yaskawa Motoman Robot Forum (Moderators: Fabian Munoz, Napierian)
| | |-+  spare input		 0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Print
Author Topic: spare input  (Read 242 times)
johnybravo
Newbie
*
Offline Offline

Gender: Male
Posts: 19
« on: November 14, 2011, 09:06:32 AM »
How do i locate an input for,i  need a 24 volt input at robot for a wire brake. do i need to run a cable from robot back to controller or could there be a spare at robot side if so where should i be looking.

Opps maybe that should be an output from controller (NX100) to robot, i need to switch on a solenoid to activate a wire brake for searching then after the search switch it back off.
Thanks
John
« Last Edit: November 14, 2011, 01:07:44 PM by johnybravo » Logged
Robodoc
Motoman Robot Support
*****
Offline Offline

Gender: Male
Posts: 229
« Reply #1 on: November 19, 2011, 02:07:49 PM »
Yes you will have to run a wire from the output of the controller to the solenoid you will use for the wire brake.  There are no spare wires that run from the controller to the robot.
Logged
Robodoc
johnybravo
Newbie
*
Offline Offline

Gender: Male
Posts: 19
« Reply #2 on: November 21, 2011, 09:19:35 AM »
Ok thanks
Logged
Pages: [1] Print 
« previous next »
Jump to:  


Login with username, password and session length

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!