Welcome, Guest. Please login or register.
Did you miss your activation email?
May 24, 2012, 12:59:18 PM
Home Help Login Register
News: Any Problems or Experience with Industrial Robots ?
Register and place your Question / Answer to worldwide Robotexperts right here !

+  Robotforum | Support for Robotprogrammer and Users
|-+  Industrial Robot Help and Discussion Center
| |-+  Yaskawa Motoman Robot Forum (Moderators: Fabian Munoz, Napierian)
| | |-+  Omron CJ1W-PRM21 to NX100 Setup (Profibus)		 0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Print
Author Topic: Omron CJ1W-PRM21 to NX100 Setup (Profibus)  (Read 323 times)
Mosteck
Newbie
*
Offline Offline

Posts: 9
« on: December 14, 2011, 08:15:10 PM »
I've never setup a Profibus network (usually DeviceNet and EthernetI/P) and trying to get an Omron CJ1W-PRM21 to communicate with a NX100.

In CX-ConfiguratorFDT, it shows that the node is connected, but there is a parameter fault.  I have the NX100 set to node 10 on Profibus and also as Station ID 10 through the Rotary Switch SW2 and the I/O Size to 64I/64O (rotary SW1 at position 8).

I'm not sure what I'm missing here.  Any help or advise would be much appreciated.

Thank you!
Logged
Mosteck
Newbie
*
Offline Offline

Posts: 9
« Reply #1 on: December 19, 2011, 10:41:43 PM »
Ended up being the wrong GSD file.  hms_1003.gsd is the correct one..
Logged
Pages: [1] Print 
« previous next »
Jump to:  


Login with username, password and session length

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!