auto shut-off function "welding on"

[waclaw84]

hello everyone

I would like to know how to disable the auto shutoff function "welding on" when i use a backward button.

Thanks for help

[95devils]

Can you explain what is happening.  Think the reason no one has replied is we don't understand the question.  What is the auto shutoff function?  

Using the backward tells me you are in teach and doing path confirmation.  In teach, you can turn on "weld in teach" but that works with Interlock- Test Start, depending on the controller.

That's all I can figure out from the question.

[waclaw84]

I toggle  NX teach pendant  in teach mode and i press the button  "welding on" and then i press the interlock and the test start button and welded. when I press the return key to go back to the beginning of the weld to improve it function "welding on" itself off. i wants all the time was attached.


sorry for my english but rarely uses it

[AtikusKhuda]

In a NX100 Job the Welding On button should stay on unless you leave the job that you are currently in to goto another job. For instance if you are in JOB: WELD_SEAM_1 then you direct open to another job the weld on will and should turn off.

[nrcole]

I believe it it is with the software, not a parameter.

[motomaster]

the "WELD ON" button is a function parameter that is enabled by motoman and there are no related parameters to change the functionality of it. I believe it is tied to "arc continue" in software and this is why it turns itself off when the backward key is used.