Welcome, Guest. Please login or register.
Did you miss your activation email?
February 08, 2012, 01:53:38 AM
Home Help Login Register
News: Any Problems or Experience with Industrial Robots ?
Register and place your Question / Answer to worldwide Robotexperts right here !

+  Robotforum | Support for Robotprogrammer and Users
|-+  Industrial Robot Help and Discussion Center
| |-+  VW Robot Forum (Moderator: Werner Hampel)
| | |-+  Loose the axes		 0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Print
Author Topic: Loose the axes  (Read 4545 times)
TINO
Guest
« on: May 25, 2007, 11:46:38 AM »
I have know a new problem with a other WV robot model G120 with VRS1-A release 1.13h2.

The problem is: I loose the axes normalize.

When I switch on the robot I get a message to normalize the axe 2, after 4 and 5. When I normalize the axes the robot works perfectly, but if I switch off and switch again I have loosen the normalization for the same axes. Sometimes I must normalize the axe 3 also, but never 1 or 6.

Can you give a idea when I can looking for? Could be battery problems, although looks good?

Thanks in advance
Logged
Wilson Li
Guest
« Reply #1 on: December 20, 2009, 11:44:49 AM »
yes, normally is battery problem
Logged
Pages: [1] Print 
« previous next »
Jump to:  


Login with username, password and session length

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!