another problem: "INTERBUS powersuply error board1"

[alb320]

Guys, I have risolved my last problem, but I have another, now!
When  I start up controller, screen show this error: "INTERBUS powersuply error board1"
What is this now???
I'm going crazy!

Thank you...

[thaipoon]

there is a problem interbus boards in the cabinet.
or İt have a problem PSU unıt.

Maybe Input Voltage High or Low

you should check all voltage output on terminals on the Power supply unit.

I will a question to you;

The escape key Or shift key already operate when the controller first opened?
VRS Robot software need to expert password?

İf you need electircal documentation this kabinet I can send it but its german!!!!

[Spider]

Hello

Could You send me this electrical documentations ? I need any documentations to this robot. Do You have any manuals to this robots?

[alb320]

Hi, Thank you for your reply.
With escape key the controller start the software in handmode only. If I try to choose SINGLE STEP or AUTOMATIC it show the error message.
VRS software don't need password but need a floppy disk (that I haven't) only for change some costants.
I have VRS electrical documentation in german, but I haven't found INTERBUS BOARD1, probably it is an optional board. Have you some planes of this?

Where are interbus board collocated in cabinet?

I'm very grateful for your support
 

[ScanRobot]

Yes I have got this error too.

Dont worry it is wery easy to get rid off. but unfortunally you need the key disc.

it is just a setting.

you have to tell the robot that there is no intebus card.

here is the solution...

ok I have just testet how to turn off the interbus carte error
press:
F2
F3
F2 (system I/O)
f4 (interbus output) change the line to "off"
esc
f5 (interbus input) change the line to "off"

it worked for me...now you can use auto...

----------

this is from my post in the german version of robot-forum:
(look in the end of the post)

http://www.roboterforum.de/roboter-forum/vw_sef_roboter/bandbreite_error-t5918.0.html
 

[alb320]

Thank you Scan... It is running now!!!