Welcome, Guest. Please login or register.
March 13, 2010, 05:01:35 AM
Home Help Search Calendar Login Register
News: Any Problems or Experience with Industrial Robots ?
Register and place your Question / Answer to worldwide Robotexperts right here !

+  Robotforum | Support for Robotprogrammer and Users
|-+  Robot Help and Discussion Center
| |-+  Stäubli & Bosch Robot Forum
| | |-+  Rx130 CS7A Output Relay		 0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Print
Author Topic: Rx130 CS7A Output Relay  (Read 435 times)
RoboFutbol
Newbie
*
Offline Offline

Gender: Male
Posts: 11
« on: January 13, 2010, 07:10:28 PM »
I just got had to swap output addresses because the first seemed to quit working. Is there any way to replace the relay contacts or do you have to replace the whold board?

SIG 43 was turning on vacuum. It would not work, although the LED in the back of the controller cycled on and off. I moved the wire from 43 to 48 and it is working fine. Fortunately, they used a variable to point to the output location, so changing it was easy.
Logged
klausi
Newbie
*
Offline Offline

Posts: 4
« Reply #1 on: January 21, 2010, 01:47:22 PM »
Hi

I guess your controller is equipped with an IO extension rack located at the back of the controller.This rack can contain, if I remember well, up to 4 IO boards.
On the output boards, each channel is fuse protected. You should check if the one four output 43 is not blown.

regards
Logged
Pages: [1] Print 
« previous next »
Jump to:  


Login with username, password and session length

Powered by MySQL Powered by PHP Powered by SMF 1.1.11 | SMF © 2006-2009, Simple Machines LLC Valid XHTML 1.0! Valid CSS!