Welcome, Guest. Please login or register.
Did you miss your activation email?
February 08, 2012, 01:33:45 AM
Home Help Login Register
News: Any Problems or Experience with Industrial Robots ?
Register and place your Question / Answer to worldwide Robotexperts right here !

+  Robotforum | Support for Robotprogrammer and Users
|-+  Industrial Robot Help and Discussion Center
| |-+  Kawasaki Robots
| | |-+  fast i/o		 0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Print
Author Topic: fast i/o  (Read 517 times)
nuni
Newbie
*
Offline Offline

Posts: 29
« on: January 12, 2010, 10:00:45 AM »
my D+ controller has a bus interface(profibus) and the standard 32 i/o (HW I/O BOARD).
Im looking for a possible fast i/o interface.does it exsist?
is the HW board faster than the profibus?
Logged
rdixiemiller
Jr. Member
**
Offline Offline

Gender: Male
Posts: 64
« Reply #1 on: January 14, 2010, 09:16:48 PM »
 Again, depends what you are trying to do. ProfiBus is fine if you are integrating with a PLC. If you need external hard wired IO, and are not using a PLC, you probably need the IO card. I run DeviceNet on a pile of FS30L robots, but I still have the IO cards in them just in case.
Logged
Regards
Robert Miller
Fanuc P50, 145,155,200,ArcMate 100,120, Kawasaki FS30,MX500, old Kobelco/Kawasaki Painters
Pages: [1] Print 
« previous next »
Jump to:  


Login with username, password and session length

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!