Welcome, Guest. Please login or register.
Did you miss your activation email?
May 23, 2012, 07:42:52 AM
Home Help Login Register
News: Any Problems or Experience with Industrial Robots ?
Register and place your Question / Answer to worldwide Robotexperts right here !

+  Robotforum | Support for Robotprogrammer and Users
|-+  Industrial Robot Help and Discussion Center
| |-+  Kawasaki Robots
| | |-+  C controller RAM battery low		 0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Print
Author Topic: C controller RAM battery low  (Read 1008 times)
tdevine77
Jr. Member
**
Offline Offline

Gender: Male
Posts: 57
« on: October 28, 2010, 09:36:02 AM »
Hello everyone,
Here lately I have been getting a non fatal error of "Ram battery low voltage" I looked this up in the manual and it says if the voltage drops below a specified voltage to change out the battery, the manual also looks like after the error it should show which board this is on but my error does not. Is this battery on the 1GA board or somewhere else?

Thanks
Tommy D
Logged
Antxoka
Guest
« Reply #1 on: October 28, 2010, 10:45:30 AM »
In C Controller you have 2 Batteries Maxell near the CPU.

You have to make a backup as soon as possible and don't turn off controller till you change batteries.

Maybe you have already lost all the Robot Program and data.
Logged
sebaog
Guest
« Reply #2 on: October 28, 2010, 04:13:17 PM »
After disconnect battery you have about 30 min. Check 2 battery : first inside controller, second inside robot.
Maxell ER17/50 Lithium 3,6V. Complet cost 100 euro for one robot  and controller.
« Last Edit: October 28, 2010, 04:43:45 PM by sebaog » Logged
tdevine77
Jr. Member
**
Offline Offline

Gender: Male
Posts: 57
« Reply #3 on: October 31, 2010, 09:03:34 PM »
Thanks guys, I found the battery and now I just need to purchase a couple.

Thanks
Tommy D
Logged
Antxoka
Guest
« Reply #4 on: November 02, 2010, 09:31:11 AM »
You also can change it without turning off controller.
Logged
tdevine77
Jr. Member
**
Offline Offline

Gender: Male
Posts: 57
« Reply #5 on: November 03, 2010, 06:39:14 AM »
Yea, but it is mounted just a little to close to the 480 volt disconnect for me to try and do that. I am going to change it out this saturday, I got one today.
Logged
tony gast
Hero Member
*****
Offline Offline

Gender: Male
Posts: 711


Can I barrow a cup of robots?
« Reply #6 on: November 03, 2010, 12:04:45 PM »
Back up the system.......Back up the system.......Back up the system.......Back up the system.......Back up the system.......
Logged
Oh, well
tdevine77
Jr. Member
**
Offline Offline

Gender: Male
Posts: 57
« Reply #7 on: November 08, 2010, 06:10:59 PM »
Battery changed with no issues, now 3 more controllers to go when I get the batteries in, thanks all for the support..
Tommy D
Logged
Pages: [1] Print 
« previous next »
Jump to:  


Login with username, password and session length

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!