how to disbale PMC in RJ3ic controller

[shinagam]

iam using a Robot which was using PMC before. i am now using
the same robot in differnt project. but for every cold start, i need to
stop run mode of PMC.

Pls let me know how can i disbale PMC from my RJ3ic controller.

your help will be greatly appreciated!!

[Dave]

Hi,
you need to have the pmcia card with the software first. then make a backup in your hard drive first because you will modify 1 file.
the file that you need modify is orderfill.dat you can open it with the note pad and looking for the line with the pmc authorization number are. delete this line, save the file and go to the robot  and reload all the software again. make an controller image first and 1 all of above backup.

let me know if you need more help.

[Vlad]

hi,

take a look at the attached pic... maye it could help.

bye
Vlad

[Vlad]

hi,

take a look at the attached pic... maye it could help.

bye
Vlad

maybe the attached pic.....

[Dave]

Vlad,

it could be usefull to shinagam and it's easy to do; the way that I propose it's to eliminate the pmc in the controller.

Everything depends of what you want you shinagan...

[shinagam]

thanks for the help Vlad and Dave.

it is really a good news after my weekend.. thankyou guyz