System Variable for %Overide increments

[Coheed]

I'm wondering if there is a system variable for % Overide incriments. On some other robots I've worked on they would go up by 5% without the shift key but by 25% with the shift key. It's really handy if you are doing a lot of programming.

Any ideas?

[FDABB]

$SHFTOV_ENB

If set to 0, the override will step up and down in fine increments of 5%. This occurs regardless of whether you press the SHIFT key. If set to 1, the override steps up and down from 50% to 100% and back if the SHIFT key is pressed. If the shift key is not pressed the override moves in fine increments.

[Coheed]

Sweet. Thank you I've been looking for that for a while.

 

[freemanleon]

SHIFT + UP should be used with great care,override will change from 5% to 50% ,again to 100%. Operators in our workshop sometime crash the part when unaware of that.