Welcome, Guest. Please login or register.
Did you miss your activation email?
May 23, 2012, 05:54:56 AM
Home Help Login Register
News: Any Problems or Experience with Industrial Robots ?
Register and place your Question / Answer to worldwide Robotexperts right here !

+  Robotforum | Support for Robotprogrammer and Users
|-+  Industrial Robot Help and Discussion Center
| |-+  Fanuc Robot Forum (Moderators: Sven Weyer, Jim Tyrer, Lerak, Napierian)
| | |-+  Rj3ib to compact logix ethernet (EGD) need help		 0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Print
Author Topic: Rj3ib to compact logix ethernet (EGD) need help  (Read 808 times)
Robopro
Guest
« on: September 09, 2010, 11:32:09 PM »
I am going to install rj3ib 430iw through ethernet , to compact logix .
has any one done this and can offer any insight?
Logged
Mlasenby
Guest
« Reply #1 on: September 22, 2010, 09:22:37 PM »
What is the PLC controlling?
Logged
Dave
Newbie
*
Offline Offline

Gender: Male
Posts: 34
« Reply #2 on: September 25, 2010, 09:13:47 PM »
hello,
if you are planning use EGD (Ethernet Global Data) the ethernet protocol it's not compatible for AB processors. You will need the Ethernet IP protocol.
please provide us more detailed info about your system.
Regards
Logged
Jim Tyrer
Administrator
*****
Offline Offline

Gender: Male
Posts: 515


Ende aller Streckenverbote


WWW
« Reply #3 on: September 25, 2010, 09:34:35 PM »
As Dave says, EIP is the option you want.
You will need a PAC code from Fanuc to enable it if it is not installed already.
I found it to be very good, easier to setup than DevNet.
Logged
Pages: [1] Print 
« previous next »
Jump to:  


Login with username, password and session length

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!