Displaying your compony Logo on the Teach Pendant

[pmax]

bnhnt,

Thank you for the reply.  To answer your question about what I have done so far, I have followed the instructions listed by regaleira on 3/23/2010.  I printed them off and took them to multiple robots with me to try this out and always got the same result which is the check mark.  I questioned you about it because on 3/29/2010 you commented that all you could get was a check mark when following these instructions but later on you said you were successful when changing the file name to a.jpg & a.htm.  I have changed the names and still will only get the check mark. 

I don't know what the size of the logo is, but if it were too small or too big wouldn't it just be distorted or hard to see on the teach pendant?

[Robotic Metallizing]

Hello Gavin:

It is very easy in ABB robots.

I have never attempted with Fanuc but I faintly remember reading a manual that says you could do it with FANUC if you have a I-pendant. In the manual it said that we have to replace the existing index.html with our preferred file. could be a logo!

I am also wondering if it was for webserver?

Good luck!

How do you do this on an ABB S4C+ / S4?

[Nation]

bnhnt,

Thank you for the reply.  To answer your question about what I have done so far, I have followed the instructions listed by regaleira on 3/23/2010.  I printed them off and took them to multiple robots with me to try this out and always got the same result which is the check mark.  I questioned you about it because on 3/29/2010 you commented that all you could get was a check mark when following these instructions but later on you said you were successful when changing the file name to a.jpg & a.htm.  I have changed the names and still will only get the check mark. 

I don't know what the size of the logo is, but if it were too small or too big wouldn't it just be distorted or hard to see on the teach pendant?

Does the file name in your html code match the image file's name?

Have you loaded the images on to the robot's FR drive?

Could you post a zip of everything you are trying to display? I could look it over and see whats wrong.