Welcome, Guest. Please login or register.
Did you miss your activation email?
May 22, 2012, 07:09:11 AM
Home Help Login Register
News: Any Problems or Experience with Industrial Robots ?
Register and place your Question / Answer to worldwide Robotexperts right here !

+  Robotforum | Support for Robotprogrammer and Users
|-+  Industrial Robot Help and Discussion Center
| |-+  Fanuc Robot Forum (Moderators: Sven Weyer, Jim Tyrer, Lerak, Napierian)
| | |-+  Cable part number for AID32F1/AOD32D1 		0 Members and 1 Guest are viewing this topic. « previous next »
Pages: [1] Print
Author Topic: Cable part number for AID32F1/AOD32D1  (Read 681 times)
JonnyRotten
Jr. Member
**
Offline Offline

Posts: 80
« on: September 16, 2010, 04:24:37 PM »
Is there somewhere to buy pre-made cables for the input and output cards we add for the fanucs?
The last one we built, we made our own cables, but that was very time consuming, and we still had some bad connections in it.
Ideally it would be the Honda connector side that plugs into the card, and then just wires at the other end, but if the other end was a plug, we could just cut it off if needed.

Any suggestions?
Logged
cobenson
Full Member
***
Offline Offline

Posts: 247
« Reply #1 on: September 17, 2010, 12:43:17 AM »
Try this place:   http://www.fanuccables.com/index.html

OR

http://www.fanucworld.com/inventory.cfm?newpos=17125
Logged
Pages: [1] Print 
« previous next »
Jump to:  


Login with username, password and session length

Powered by MySQL Powered by PHP Powered by SMF 1.1.16 | SMF © 2011, Simple Machines Valid XHTML 1.0! Valid CSS!