S4C to Autoinvision II cable

[Industrialrobotix]

Hello...anyone have available the pinout from the ABB Combi I/O DSQC327 to Miller Autoinvision II welding power supply?

Thanks!

[ABB robter]

The board is a standard combi I/O card the EIO file will have the I/O defined which will match the miller interface.
Do you have the Miller interface pin-out or definitions?
If so send it and the EIO file and I can define it for you.

[Industrialrobotix]

Thanks for the info...we have a very poor pinout of the Miller I/O...thats where our problem lies - the Autoinvision II manual is too vague....there is a possiblilty that we have it pinned incorrectly which could be causing our issues....so I figured if we had the pinout of the cable we could check it against that....